MFB Tanzbär Lite - MIDI-Dump-Functions

MFB Tanzbär Lite MFB Tanzbär LiteMIDI / Setup Functions
36 37
MIDI / Setup Functions
Step key 3: MIDI Ctrl send on/off
Selects whether Tanzbär Lites front panel controls will transmit MIDI controller data or not.
Default setting = off
Step key 4: MIDI Clk send on/off
Selects whether Tanzbär Lite transmits MIDI clock data while the sequencer is running.
Default setting = on
Step key 5: MIDI Clk Thru on/off
Selects whether Tanzbär Lite transmits incoming MIDI clock data to its MIDI out socket or
not.
Default setting = off
Step key 6: MIDI Clk Receive on/off
Selects whether Tanzbär Lite receives MIDI clock data or not.
Default setting = on
Step key 7: Manual Trigger REC
This function determines whether steps set „live“ in Manual Trigger mode (by step keys, or
received via MIDI) will be recorded into the current pattern or not. In other words: You can
enable the Manual Trigger function through this setting. If this setting has been disabled,
instruments can be triggered via step keys or MIDI notes but the steps will not be recorded.
Default setting = off
Step key 8: Saving track mutes
This function determines whether track mutes (please see page 13) will be saved into the
current pattern when using the „Store Pattern“ function. The function is active when step
LED #8 lights up.
Please note that this function is not labelled on Tanzbär Lite‘ frontpanel.
Default setting = off
MIDI dump functions
Tanzbär Lite allows for transmitting the current pattern bank as a MIDI SysEx datale.
Apart from that, a pattern bank, sent from a suitably equipped MIDI device, can be recei-
ved by your Tanzbär Lite.
These functions are only available in Play mode (see page 11). The sequencer must be
inactive.
Sending pattern bank
By using the shift function you can send the current pattern bank to a suitable MIDI device.
e.g. your DAW.
• Hold Shift + press Step key 9 (Dump Patt Bank).
The LEDs of the step keys visualize the progress of the data upload: The LED of the
corresponding pattern that is currently being transmitted is ashing. As soon as the data
transmission has been completed, the function will exit automatically.
Receive pattern banks
As long as the sequencer is inactive, Tanzbär Lite will always be ready to receive a pattern
bank as SysEx datale. You do not need to enable any additional functions. The LEDs of
the step keys will again tell you about the progress of data transmission.
Attention: When receiving a bank dump, the pattern bank currently selected
will be overwritten. There is no undo! So please think (…) twice if you really
want to send a bank dump to your Tanzbär Lite!