MFJ-1270C/1274C COMPUTER INTERFACING
Page 13
case, place a jumper across pin 1 and 2 of JMP 1. The DCD LED on the front
panel will function normally indicating received packets.
Apple Macintosh
The MFJ Starter Pack for the Macintosh (MFJ-1287) includes a terminal
program and a cable to connect the MFJ TNC to the Macintosh. If you should
want to use a terminal program such as MacTerm set the options according to
Table 2-3.
Compatibility Terminal
1200 baud VT100
7 bits/character ANSI
even parity UNDERLINE
Handshake Xon/Xoff US
modem connection 80 Columns
"telephone" port ON LINE AUTOREPEAT
Table 2-3. MacTerm option settings for operation with MFJ TNC
Apple II, II+, IIe, IIc
For the Apple II family of computers with Apple or third- party serial interface
cards, you may use ASCII Express Pro, Hayes Smartcom IIe and DataCapture
4.0 for the MFJ TNC . There are others which may be compatible with the MFJ
TNC , but have not been tested.
Commodore C64, C128 and VIC-20
The optional Starter Pack for the C-64, C-128 and VIC-20 can be purchased
from MFJ Enterprises, Inc. or from any MFJ dealer. Starter Pack includes an
interface cable from the MFJ TNC TTL port to the user I/O port on the
commodore computer. A terminal program is also included. To order, specify
MFJ-1282 for software on disk or MFJ-1283 for software on tape.
If you do not have the MFJ Starter Pack then you may use the BASIC
communications program is given in the Programmer's
Reference Guide
To Next Page
Loading...