MFJ-1270C/1274C MANUAL BASIC OPERATION
Page 30
GETTING STARTED
This chapter will guide you through the basic packet operation on your MFJ
TNC.
First Steps
1. Make sure that your computer is connected to the RS-232C port or the TTL
port on the MFJ TNC according of Chapter 2.
2. Make sure that your radios are connected to the MFJ TNC according to
Chapter 3.
3. Turn on your computer. Load and run the terminal program.
4. Turn on the MFJ TNC. The MFJ TNC will sign on with "cmd:" prompt
sign.
*:J
bbRAM:LOADED WITH DEFAULTS
|A
MFJ ENTERPRISES, INC.
MODEL MFJ TNC
AX.25 Level 2 Version 2.0
Release XXXXX (date) - XX K RAM
Checksum XXX
cmd:
Note: The "|A" may display as a vertical-bar and any capital letter from "A"
through "J".
The first five lines are the sign-on message, which you will normally see only
when you power up the MFJ TNC . The Command Mode prompt cmd: will
appear when the MFJ TNC is in Command Mode and is ready to accept your
instructions. Before the MFJ TNC can be fully operational, some of the basic
parameters must be set.
To Next Page
