MFJ-1270C/1274C MANUAL ADVANCED OPERATION
Page 55
not very important, and most serial ports will recognize a BREAK if the space
signal lasts significantly longer than the time required for a character
transmission. Because of the simple nature of this signal, it is easily possible to
generate a BREAK with circuitry external to the computer, thus guaranteeing
entry to Command Mode in automatic station operation.
The following commands set special characters which are active in Converse
Mode. Refer to the discussions of these commands for details on the operation
of the characters in Converse Mode.
CANLINE cancel current line
CANPAC cancel current packet
COMMAND Command Mode entry
DELETE character deletion
MFILTER characters to be filtered in monitored packets
PASS insert following special character
REDISPLA re-display current line
SENDPAC send current packet
START, STOP user's flow control characters (sent to MFJ TNC)
XOFF, XON MFJ TNC flow control characters (sent to to
terminal)
The following commands enable display features which are active in Converse
Mode. Refer to the discussions of these commands for details on the operation
of these characters in Converse Mode.
8BITCONV Retain high-order bit from serial port in converse
mode
AUTOLF Add <LF> after <CR>
BKONDEL Echo after character deletion
ECHO Automatic echo of serial input
ESCAPE <ESCAPE> translation
FLOW Type-in flow control
LCOK Lower case translation
NUCR Null characters after <CR>
NULF Null characters after <LF>
NULLS Null count
SCREENLN Automatic <CR> insertion
Transparent Mode
To Next Page
Loading...
