Electrical
Warning
Access to the bulbs is gained from the back of the fascia or by removing the
panel
and
centre console.
illumination
lamps
Centre console. Remove the
four
screws (12) on each side, securing the centre
Figs. 10
and
11 console. Withdraw the console, tilting the top forward slightly to clear the under
edge of the fascia. '
Heater
control lamp bulb. Remove the push-fit bulb holder
(l)
from the control
and
remove the bayonet fixing type bulb (2).
Instrument panel lamp bulbs. Remove the push-fit bulb holders (3) from the
instruments and unscrew the bulb (4).
Warning lamp bulbs. Remove the push-fit bulb holders (5) from the lamps and
remove the bayonet type fixing bulbs (6). To remove the ignition and high
beam warning bulbs the centre console must also be withdrawn.
Lights and heater booster switch bulbs. Remove the push-fit bulb holders (7)
from the switches and remove the bayonet type fixing bulbs (8). To remove the
lights switch bulb the centre console must also be withdrawn.
Brake failure warning lamp. Remove the retaining spring clip (9)
and
withdraw
the holderftest-push assembly from the fascia.
Through
the two pivot holes in
the holder depress the pivot legs (10)
and
remove the test-push rocker from its
holder. Unscrew and remove the bulb (11).
Fig. 10
4
~~
3
Fig. 11
Hazard switch bulb.
W
~thdraw
the centre console. Remove the push-fit bulb
holder (13) from the switch, and remove the bayonet fixing type bulbs (14).
Seat
belt warning lamp bulb. Withdraw the centre console. Remove the push-fit
bulb holder (16) from the lamp
and
remove the bayonet fixing type bulb (15).
Cigar lighter illumination bulb. Withdraw the centre console. Squeeze the sides
of
the bulb .hood (17) and remove the hood. Remove the bulb holder (18) from
the
hood
clip
and
remove the bayonet fixing type bulb (19).
f:G
15 16
~
To Next Page
Loading...
