Mi-Light MiBoxer - 2.4 G RF Remote Control Instructions; Linking Code Instructions; Unlinking Code Instructions

1). Linking Code Instrucons
Power off 10 seconds and
power on again or short press
"SET" one me or turn on
light via PUSH switch
Short press " I " buon
3 mes within 3 seconds.
Lights blink 3 mes
slowly means linking
is done successfully.
Linking failed if light is not blinking slowly, Please follow above steps again.
(Note: Light that have linked can't link again)
2). Unlinking Code Instrucons
Power off 10 seconds and
power on again or short
press "SET" one me or turn
on light via PUSH switch
Short press " I " buon
5 mes within 3 seconds.
Lights blink 10 mes
quickly means unlinking
is done successfully.
Unlinking failed if light is not blinking quickly, Please follow above steps again.
(Note: Light haven't linked that don't need to unlink)
2.4G RF Remote control instrucon
Link / Unlink
buon
Power Light
Power Light
2
3
1
or
or
SET
Link / Unlink
buon
Power Light
Power Light
2 31
PUSH
or
or
SET
PUSH
⸺ 4 ⸺