Mi Swaco 414

43
a. Clean any dirt and grease from the mating surfaces of the large
end piece and the flange. Remove any residual Loctite from
the splined surfaces of the end piece and the flange.
b. Apply an even coat of Loctite 225/222 on the end piece splines.
Install the flange on the end piece.
c. Install lockwasher, Item 2, and the round nut, Item 1, Figure
16.
NOTE: The flange face that bolts to the gearbox must run true to
prevent any gearbox runout.
Section 6: Diagrams and Parts Lists
1. 414 Centrifuge
2. Bowl Assembly
3. Gearbox End Assembly
4. Feed End Assembly
5. G.S. Coupling
6. Frame
7. Vessel
8. Conveyor
9. Shim Selection
10. 350 KPM Gear Box
11. Electrical Assembly
12. Electrical Wiring Diagram
13. Electrical Cabling
14. Electrical Schematic Diagram
15. Feed Pump Electrical Diagram (Typical)
16. Special Tools