Why is my Mi Swaco 414 vibrating?
If your Mi Swaco Laboratory Equipment machine vibrates, it might be due to an imbalanced bowl from inadequate cleaning, mismatched parts, or uneven wear. Alternatively, the vibration damping mounts may have lost their elasticity. Inspect the bowl to see if any of the mentioned causes are present. If the mounts have lost elasticity, replace them.
What to do if motors do not start on Mi Swaco 414 Laboratory Equipment?
If the motors on your Mi Swaco Laboratory Equipment do not start, first ensure that the unit is receiving power. If power is available, check if the vibration switch needs to be reset as described in Section 1.3.1. Also, verify that the limit switch on the G.S. Coupling hasn't tripped; reset it as described in Section 1.3.1.
General| Brand | Mi Swaco |
|---|---|
| Model | 414 |
| Category | Laboratory Equipment |
| Language | English |
Describes the bowl, conveyor, gearbox, frame, vessel, and feed tube.
Explains how the torque limiter prevents overload and triggers safety switches.
Describes the fluid coupling's role in motor acceleration and overload prevention.
Addresses the risks associated with back drive motor overspeed and mitigation.
Guidelines for safely moving centrifuge parts to prevent damage.
Instructions for securely mounting the unit and ensuring it is level.
Lists checks for the centrifuge during shop inspections, including noise and gearbox oil.
Explains how and when to lubricate pillow block and conveyor bearings.
Step-by-step guide for safely removing the rotating assembly from the centrifuge.
Explains correct bearing alignment and housing procedures for the rotating assembly.
Describes the level regulating discs and their function in the bowl.
Explains how to achieve correct clearance using shims for the conveyor.
Outlines the steps for installing the conveyor into the bowl.
Details installation, dismantling, and maintenance for Gyrol Fluid Couplings.
Explains how to measure and record conveyor wear over time.
Installation steps for the inline JCO model coupling.
Installation steps for JQD model shaft mounted couplings.
To Next Page