MICODUS MP50G - Add Center Number; Set Up GEO-Fence

Add Center Number
Delete Center Number
Set Up GEO-Fence
CENTER,A,
center number#
CENTER,D#
FENCE,S,R,LNG,LAT#
Geo-fence Parameters FENCE#
Delete GEO-Fence DFENCE,S#
Search Mode SEARCH#
Buzzer Switch BEEP,A#
LED Switch LED,A#
DEL CENTER OK
Example:
FENCE,1,500,22.65897,114.985231# ( Means set
up the fence 1 as center dot 22.65897,114.985231,
radius 500m )
FENCE,2,300,,# ( Means set up the fence 2 with the
center dot as the last GPS fixed position, radius:
300m)
S=1～4, fence serial number
R=100-65535m, Radius value
LNG=Longtidue of the center dot
LAT=Latitude of the center dot
NOTE: 1. Fence only can be setup when the device
has GPS signal, if no GPS signal, then reply:
Unable to set GEO fence now, please fix the GPS
location firstly!
2. User can set with or without coordinates in the
command, if without coordinates then it will set up as
the last GPS fixed position
ID: 19172012644 (Device ID number)
FENCE1: 500m(Radius),
22.65897,114.985231(center coordinate)
FENCE2: 300m(Radius),
22.65897,114.985231(center coordinate)
FENCE3: 400m(Radius),
22.65897,114.985231(center coordinate)
FENCE4: 400m(Radius),
22.65897,114.985231(center coordinate)
Example:
DFENCE,1# (Means delete the fence 1)
DFENCE,0# (Means delete all fence)
S=0～4, fence serial number
Example: SEARCH#
Note: 1. After received this command, device will
start live tracking every 10 seconds and last for 10
minutes.
2. When there is an Geo-fence alarm, this search
mode will be activated automatically
Example: BEEP,ON#
BEEP,OFF#
Example: LED,ON#
LED,OFF#
Set 3 numbers at a time:
SOS,A,13800138000,1380013800 1,13800138002#
Set the first numberseparately:
SOS,A,13800138000#
Set the second number separately:
SOS,A,,13800138001#
Means to set 3rd number separately:
SOS,A,,,13800138002#
Directly delete the number:
SOS,D,13800138000#
Delete 1st number:
SOS,D,1#
Delete 2nd number:
SOS,D,2#
Delete the 2nd and 3rd number:
SOS,D,2,3#
Example: CENTER,A,+8613800138000#
Note: Please set up the center number with the
country code as prefix!
Example: GMT,E,8# (if no half time zone)
GMT,W,9,30# (if has half time zone)
NOTE: Parameter : E / W; 0 ~ 12; 0/15/30/45