Unclassified
Installation Procedure
3-4
NOTE
Before installing the RM500/RM500R on slides, make
sure you are familiar with the procedures needed to
install slides in the rack/cabinet, and safely install
heavy equipment on the slides.
3.7.1 INSTALLATION PROCEDURE – BASIC RADIO
a. Identify the installation position of the RM500/RM500R in the rack.
b. Install the RM500/RM500R in the prescribed installation position, fastening it by
means of four screws to the rack rails or to the drawer front.
c. Connect grounding straps from each of the two RM500/RM500R grounding screws
(located on its rear panel), to the prescribed cabinet’s grounding bar.
d. Set the power switch on the RM500/RM500R front panel to OFF (down position).
e. Connect cables to the unit as follows:
Connect the RM500/RM500R AC power cable to the prescribed outlet on the
power distribution box of the cabinet.
Connect the antenna feed cable to the RF OUT connector of the
RM500/RM500R.
When an external device is used, connect the prescribed cable to the accessories
connector of the RM500/RM500R that supports the corresponding device.
f. Connect audio accessories to the front panel connectors.
To Next Page
Loading...
