To Next Page

To Previous Page

Gas Heat Override

This feature turns on the gas furnace from an electric heat mode when the setpoint is five or

mode degrees away from the ambient temperature and heating is required. It is only available on

systems that have both gas and electric heating and is only active in electric heat or cool/electric heat

modes. The feature can be disabled from the settings/ heat sources screen entered by using the dip

switch icon.

If heating setpoint is 5 degrees or more above the inside temperature in an electric heating

mode, the furnace will come along with the electric heater. Heat pumps will run an additional minute

before shutting down and heat strips will continue to run until the set point is reached.

When the furnace is actively overriding the electric heat, a furnace symbol will appear at the top

of the thermostat screen.

Smart device application only features

Reset device

This Bluetooth only feature allows resetting the display just as if you removed and restored

power.

Calibrate Touchscreen

It is normally not necessary to recalibrate the touchscreen. This selection prompts the user to

press the four corners of the display then test the calibration using three diagonal marks. This feature is

only available from Bluetooth since being at the thermostat is required.

Check for updates

Checks to see if any updates are available for the thermostat. The smart device application must

have internet and the thermostat must be connected to WIFI with a green WIFI symbol. Tap Check for

Updates and follow the prompts.

Notifications

Notifications allow setting a minimum and maximum allowed temperature to be set. If the

temperature is exceeded, the thermostat will send a push notification to your smart device. WIFI must

be connected and active on the thermostat for the notification to function. Notifications will be sent for

each degree of temperature change.

MICRO-AIR EasyTouch 352 User Manual

Questions and Answers: