26
LCD contrast can be adjusted via the menu sequence ⌐S
ETUP ⌐DISPLAY
⌐CONTRAST. Use the {◄} / {►} keys to adjust contrast to the desired setting.
Press {Ο} to save the setting, or press {Menu} to exit without changing the
contrast setting.
LCD brightness can be adjusted via the menu sequence ⌐S
ETUP ⌐DISPLAY
⌐BRIGHTNESS. Use the {◄} / {►} keys to increase or decrease brightness. Press
{Ο} to save the setting, or press {Menu} to exit without changing the brightness
setting.
Note: A brighter backlight requires more battery power. Setting the backlight
brightness to a value greater than needed will decrease battery life.
Power-Up Logo
At power up, the ES3 logo can either scroll slowly onto the screen or just appear as
a full-screen display. This option is set via the menu sequence ⌐S
ETUP ⌐DISPLAY
⌐SCROLL LOGO. Select “Yes” for the scrolling display, or “No” for the full-screen
display.
Note: If the ES3 powers down due to an inactivity timeout, the logo display will be
skipped when the instrument is powered back up to minimize re-start time. Re-
start will proceed directly to the manual audiometry screen.
Real-Time Clock Settings
The date format is selected via the menu sequence ⌐SETUP ⌐DATE ⌐SET DATE
FORMAT. The format may be set to mm/dd/yyyy or dd/mm/yyyy. The date may
be set (or viewed) via the menu sequence ⌐S
ETUP ⌐DATE ⌐SET DATE. A new date
must be entered in the currently selected date format (i.e., dd/mm/yyyy or
mm/dd/yyyy). Press {Ο} to save the date setting, or {Menu} to exit without
changing the time setting.
The time format (12 or 24 hour) can be selected via the menu sequence ⌐S
ETUP
⌐DATE ⌐SET TIME FORMAT. The ES3 real time clock can be set (or time viewed) via
the menu sequence ⌐S
ETUP ⌐DATE ⌐SET TIME. A new time must be entered in the
currently selected format (12- or 24-hour). Press {Ο} to save the time setting, or
{Menu} to exit without changing the time setting.
To Next Page
Loading...