4. Optical Charts
i
Make sure that the focus of thermal channel is adjusted correctly.
If necessary, focus the thermal imaging camera with the optics, see Fig. 1.
The turning out of the optics leads to the focus setting “near” and the turning in of the lens to the focus set-
ting “infinity”.
i
The visual camera (TIM 200/ 230 only) is adjusted with the supplied focusing tool, see Fig. 2.
For this purpose, the focusing tool with the two pins is placed on the visual camera and is focused to „near“
by a left turn and focused to „infinity“ by a right rotation.
IR-Kanal
VIS-Kanal
Fig. 1 thermoIMAGER TIM 200 / TIM 230 with
VIS channel
Fig. 2 Focusing tool for VIS camera
To Next Page
Loading...
