7. Commissioning
Please install at first the software TIM Connect from the delivered CD.
i
Further information regarding software installation as well as software features you will find in the
instruction manual supplied on the CD.
Now you can connect the thermoIMAGER TIM camera into an USB port (USB 2.0) of your PC.
If connecting the thermoIMAGER TIM camera and the computer please plug at first the USB cable into
the camera and then into the computer.
If disconnecting the thermoIMAGER TIM camera and the computer please remove at first the USB cable from
the computer and then from the camera.
> Damage to or destruction of the camera
After the software has been started, you should see the live image from the camera inside a window on your
PC screen, see Fig. 26.
+
Fig. 26 Live image of camera
At first start of software you will be asked to install the calibration data of camera. You will find them on the
supplied CD.
The sharpness of the image can be adjusted by turning the exterior lens ring at the camera.
To Next Page
Loading...
Need help?
General
