Controlled conditions on camera
and software
Standard process interface
TM-PIF-TIM
Industrial process interface
TM-PIF500V2-TIM
Interruption USB cable to camera
Interruption data cable camera - PIF
Interruption power supply - PIF
Shut-down of TIM Connect software
Crash of TIM Connect software
1
-
Fail-safe output 0 V at analog output (AO) Open contact (Fail-safe relay)/
green LED off
1) Depending on supply voltage; for 0 - 10 V on the AO the PIF has to be powered with min. 12 V.
2) Active if AO1, 2 or 3 is/ are programmed as alarm output.
Alarm: Relay open LED off
Normal: Relay closed LED on
Fail-safe status:
TIM Connect
Fig. 41 Example 2 for a fail-safe monitoring of the TIM with a PLC
To Next Page
Loading...
