Microchip Technology IS2083 - Page 92

 2021 Microchip Technology Inc. DS00003118C-Page 92
AN3118
• Upon successful tuning, the message shown in
the following figure appears:
FIGURE 104: STATUS OF SUCCESSFUL
TUNING MESSAGE
P.1.2 DYNAMIC TUNING COMMANDS
The following set of commands (see following figure)
are used for tuning the parameters effectively:
FIGURE 105: DYNAMIC TUNING
COMMANDS
• Reset Parameters
- Reload the parameters from Flash. All the
unsaved parameters will be Reset
•Reset DSP
- Reset DSP of the IS2083
• Reset DUT
- Reset IS2083 (8051 and DSP) and all the
parameters will be Reset
• Save Parameters to Flash
- Save the tuned parameters to Flash (runtime
section) to in order to bring back the saved
parameters after the power cycle
• Restore Factory Default Settings
- Restore the parameters to factory settings
and Reset the IS2083 after restoring the
parameters