2016-2023 Microchip Technology Inc. DS50002489G-page 41
RN4870/71
User Manual Notice for License-Exempt Radio Appara-
tus (from Section 8.4, RSS-Gen, Issue 5, March 2019):
User manuals for license-exempt radio apparatus shall
contain the following or equivalent notice in a conspic-
uous location in the user manual or alternatively, on the
device or both:
Transmitter Antenna (from Section 6.8 RSS-GEN,
Issue 5, March 2019): User manuals for transmitters
shall display the following notice in a conspicuous
location:
Immediately following the above notice, the manufac-
turer shall provide a list of all antenna types approved
for use with the transmitter, indicating the maximum
permissible antenna gain (in dBi) and required
impedance for each.
11.2.2 RF EXPOSURE
All transmitters regulated by the Innovation, Science and
Economic Development Canada (ISED) must comply
with RF exposure requirements listed in RSS-102 - Radio
Frequency (RF) Exposure Compliance of Radio
Communication Apparatus (all frequency bands).
This transmitter is restricted for use with a specific
antenna tested in this application for certification, and
must not be co-located or operating in conjunction with
any other antenna or transmitters within a host device,
except in accordance with Innovation, Science and
Economic Development Canada multitransmitter
guidelines.
The installation of the transmitter must ensure compliance
is demonstrated according to the ISED SAR procedures.
11.2.3 APPROVED ANTENNAS
For RN4870, the approval is received using the
antenna listed in Figure 8-1.
For RN4871, the approval is received using the
antenna listed in Figure 8-2.
11.2.4 HELPFUL WEBSITES
Innovation, Science and Economic Development
Canada (ISED): http://www.ic.gc.ca/.
11.3 Europe
The RN4870/4871 module is Radio Equipment
Directive (RED) assessed, CE marked, and has been
manufactured and tested with the intention of being
integrated into a final product.
The RN4870/71 module has been tested to RED 2014/
53/EU Essential Requirements mentioned in the
following European Compliance table.
This device contains license-exempt transmit-
ter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s
license-exempt RSS(s). Operation is subject to
the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage.
2. L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le
fonctionnement.
This radio transmitter [IC: 12246A-BM70BLES1F2
and IC: 12246A-BM71S2] has been approved by
Innovation, Science and Economic Development
Canada to operate with the antenna types listed
below, with the maximum permissible gain indi-
cated. Antenna types not included in this list that
have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited
for use with this device.
Le présent émetteur radio
[IC: 12246A-BM70BLES1F2 and IC: 12246A-
BM71S2] a été approuvé par Innovation, Sciences
et Développement économique Canada pour
fonctionner avec les types d’antenne énumérés
cidessous et ayant un gain admissible maximal.
Les types d’antenne non inclus dans cette liste, et
dont le gain est supérieur au gain maximal indiqué
pour tout type figurant sur la liste, sont strictement
interdits pour l’exploitation de l’émetteur.
TABLE 11-1: EUROPEAN COMPLIANCE
Certification Standards Article
Safety EN 62368 3.1(a)
Health EN 62311
Electromagnetic
Compatibility (EMC)
EN 301 489-1 3.1(b)
EN 301 489-17
Radio EN300 328 3.2
Downloaded from Arrow.com.
To Next Page
Loading...
Need help?
General
