Need help?Do you have a question about the microjig MATCHFIT and is the answer not in the manual?
General| Type | Dovetail Clamp |
|---|---|
| Material | Steel |
| Dovetail Groove | 1/2 inch, 14 degree dovetail groove |
| Color | Black |
| Function | Secures workpieces during woodworking |
Describes the 3-in-1 functionality as a tall fence, jointing sled, and tapering jig.
Cut a 3/4" thick plywood sheet to the length of your table saw's rip fence.
Route relief grooves along the long and short sides of the plywood using a router.
Route 1/2" 14-degree dovetail tracks in the same locations as the relief grooves.
Chop corners at 45 degrees and chamfer two short sides and one long side.
Cut and route 1/4" slots and heels into plywood blocks for tapering jig stops.
Insert clamps in tracks and secure the jig to the rip fence for added support.
Lay sled flat, align edge, adjust fence, and secure workpiece to cut a straight edge.
Align workpiece, place stops, lock them, and clamp workpiece to make repeatable taper cuts.
To Next Page
