MMiiccrroommaarrkk
DDeevvoonnsshhiirree HHoouussee,, 555500 WWhhiittee HHaarrtt LLaannee,, LLoonnddoonn NN1177 77RRQQ
Micromark continuously tries to improve its products for the benefit of its customers. For this reason we reserve the right to make changes to any product at any time, without notice.
MICROMARK INSTRUCTIONS MM25201/160805 © Micromark 2005
If you have any difficulty with this Alarm System, please check the following before telephoning the Helpline.
PPRROOBBLLEEMM
SSOOLLUUTTIIOONN
When finishing programming and pressing
PP00EE
internal
alarm sounds.
Unable to set system. Zone LED illuminated.
Panel showing fault.
• Tamper spring on panel not depressed.
• Bad connections at terminal block.
• Tighten wall screw and refit.
• Check terminal block connections.
• Door open or PIR is getting tripped by someone
moving.
• Close doors and keep still while entering password.
• Door contacts not close enough – 5mm.
• Move contact magnet closer.
TROUBLESHOOTING
PPOOSSSSIIBBLLEE CCAAUUSSEE
**PPLLEEAASSEE NNOOTTEE:: TToo mmaaiinnttaaiinn ooppttiimmuumm sseeccuurriittyy,, tthhee bbaatttteerryy sshhoouulldd bbee cchheecckkeedd rreegguullaarrllyy aanndd rreenneewweedd eevveerryy yyeeaarr..
TThhiiss aapppplliiaannccee//ffiittttiinngg iiss mmaarrkkeedd aaccccoorrddiinngg ttoo tthhee EEuurrooppeeaann ddiirreeccttiivvee 22000022//9966//EECC oonn WWaassttee EElleeccttrriiccaall aanndd EElleeccttrroonniicc EEqquuiippmm