Need help?Do you have a question about the Microsat WX3IN1 and is the answer not in the manual?
Receives and sends data via APRS radio, handles frames, forwarding, and beacon sending.
Connects to APRS-IS servers to send received APRS radio data.
Forwards messages from APRS-IS server to APRS radio if destination station is heard.
Receives and encodes weather data from WS2300/WS2350 stations for APRS transmission.
Steps to select COM port and open a connection to the device using the configurator software.
Utilize the 'READ CONFIG' button to download current configuration values from the device.
Use the 'WRITE CONFIG' button to upload configured parameters to the device's internal memory.
Procedure to upload new firmware using the 'UPLOAD FIRMWARE' option in the software.
Configure Callsign, TX delay, Quiet time, and PTT output options for radio communication.
Configure digipeater function, duplicate checking, and path settings for packet forwarding.
Configure beacon transmission, including destination, path, rate, and message content.
Configure IP addresses, network masks, gateway, and APRS-IS login for internet gateway functionality.
Settings for sending weather reports: latitude, longitude, DigiPath, comment, and transmission rates.
Details on the internal real-time clock, battery backup, and safety warnings for battery replacement.
To Next Page
General