Microsemi ATS-6501 T-Flex - Page 142

DOC 6501_Release V
ATS-6501 Users Guide
134
[2]
[alarm_text] n/a
[status] good
[3]
[alarm_text] n/a
[status] good
[4]
[alarm_text] n/a
[status] good
[power] enabled Power status on the card.
[sram_write_busy] false True = write to memblock in progress
[streams] Provides status on all of the bitcode streams
[1]
[busy] true
[enabled] true
[underflow] false
[2]
[busy] true
[enabled] true
[underflow] false
[3]
[busy] true
[enabled] true
[underflow] false
[4]
[busy] true
[enabled] true
[underflow] false
[type] 4391A
[OK] 2014-05-01T11:18:12Z
System Errors: Alarms and events on the ATS-6501 are available via the status command. As
the events occur the system will set the alarm and time. Once the condition clears the system will
indicate the condition cleared, what the condition was, when it cleared and increment the
occurrence counter.
[clock_wander]
[active] false
[cleared]
[what] Clock wander is less than 100.000000ns
[when] 2009-01-26-22:18:48.141
[occurrences] 1
[set]
[what] Clock wander exceeded 100.000000ns
[when] 2009-01-26-22:18:35.922