Microsemi ATS-6501 T-Flex - Page 39

DOC 6501_Release V
ATS-6501 Users Guide
31
[ports]
[1]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[2]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[3]
[epoch_127] false
[format] G
[signal_word] 141
[type] irig
[4]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[OK] 2013-08-05T16:40:12Z
• NASA36: To set the NASA 36 Code for the individual ports use the nasa36
command:
ATS-6501> nasa36 [slot#] [port#]
The following example sets the Time Code for Slot 5, Port 3 to NASA 36.
ATS-6501>nasa36 5 3
OK
[OK] 2013-08-05T16:41:25Z
The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the settings hardware:slots:N command (where N=Slot #) to
obtain the current settings for a particular card.
ATS-6501> settings hardware:slots:5
[tsc4387]
[ports]
[1]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[2]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[3]
[epoch_127] false
[format] B
[signal_word] 127
[type] nasa36