DOC 6501_Release V
ATS-6501 Users Guide
83
2. The [satellite] [number] field should be at least 4. If the value is 0 then no satellites
are being tracked. Wait ten-fifteen minutes after the Oscillator Lock light is Green to
give the system a chance to acquire satellites. If the value is still 0 fifteen minutes
after the Oscillator Lock light turned green then there is likely a problem with the
antenna setup.
If you are using the manual position mode and the system is reporting satellites but
the GPS Tracking indicator is off the position entered is incorrect. Verify the
position was entered correctly. If this problem persists, switch the system to the auto
mode (position_mode auto) and allow the system to resurvey the antenna position.
3. The [gps] [satellite] [signal] [freq] field indicates whether single frequency or dual
frequency measurements are being received from the receiver. If only single
frequency measurements are being received then check the antenna and make sure
that it is the Novatel (L1/L2) antenna included with the unit. If you are not using the
supplied antenna the system may be connected to a single frequency (L1) antenna.
E. Both fans should be operating properly.
[hardware]
[fan]
[1] true
[2] true
F. Verify the system hardware is operating properly by ensuring the system is displaying the
proper serial number, the outputs are enabled, the power supply status is good and it
displays the correct model #.
[mainboard]
[EUID] 00:30:96:02:00:00:00:f6
[serialnum] SP00253
[type] 4370A-140
[outputs]
[enabled] true
[slots]
[1]
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4394A
[2]
[type] empty
[3-5] Should reflect the installed card.
[6]
[ports]
[1]
[fiber_status]
[local_tdc] 3.091836734693877e-08
[remote_device] 6511
To Next Page
Loading...
