Microsemi ATS-6501 T-Flex - Page 94

DOC 6501_Release V
ATS-6501 Users Guide
86
[active] false
[occurrences] 0
[oscillator_control]
[active] false
[occurrences] 0
[signal_gain]
[active] false
[occurrences] 0
[leapseconds]
[internal_error]
[active] false
[occurrences] 0
[unknown]
[active] false
[occurrences] 0
[ocxo_freq_control]
[active] false
[occurrences] 0
Note: Any GPS Errors recorded when the unit first starts up may be reported, if so, they will
always have a date of 1 Jan 1998.
K. Each port [1-4] on each output module [1-6] should have zero active errors and the
[outputs disabled] and [outputs unlocked] active blocks should be false. The [power
supply] [0-1] active blocks should also be false.
[output_modules]
[1]
[active] false
[occurrences] 0
[ports]
[1]
[active] false
[occurrences] 0
[2]
[active] false
[occurrences] 0
[3]
[active] false
[occurrences] 0
[4]
[active] false
[occurrences] 0
[2]
[active] false
[occurrences] 0
[ports]
[1]
[active] false
[occurrences] 0
[2]
[active] false
[occurrences] 0
[3]
[active] false
[occurrences] 0
[4]
[active] false
[occurrences] 0
[3]