Need help?Do you have a question about the Microsoft Flight Simulator DOUGLAS DC-3 and is the answer not in the manual?
Steps required after using the auto-start function for engine startup.
Steps required after using the auto-shutdown function for engine shutdown.
Important note regarding Energize and Mesh switches during engine start.
Key physical dimensions of the DC-3 aircraft.
Weight details for the DC-3, including empty, basic, and gross weights.
Additional performance data such as cruising speed and stalling speed.
Detailed breakdown of the components found on the DC-3's control pedestal.
Procedure for operating the manual hydraulic pump in emergencies.
Function and operation of the hydraulic flow selector lever.
Information on using modern avionics like GNS530/430 and modern Autopilot.
Essential checks and procedures to perform before taxiing the aircraft.
Covers engine run-up, ignition, and hydraulic pump checks during taxiing.
Specific techniques for taking off in crosswind conditions.
Steps for retracting and extending landing gear after takeoff.
Steps to engage and operate the Sperry Gyro Pilot for flight stabilization.
Information specific to the A3 Gyro Pilot model.
Important notes on the capabilities and limitations of the Gyro Pilot.
Handling characteristics during normal turns.
How to recognize stalls and the procedures for recovery.
Chart detailing stalling speeds under various conditions.
Specific methods for landing the aircraft in crosswind conditions.
How to perform a landing without using flaps.
Steps for safely parking the aircraft after landing.
Setting up weight and balance parameters for the simulation.
Checklist items to complete before starting engines.
Checklist items for the engine starting sequence.
Explanation and caveats for using the auto-shutdown function.
To Next Page
General