Insert batteries according to the instructions
provided below.
If you use your racing wheel with an Xbox 360
Rechargeable Battery Pack, see the manual
that came with the battery pack for important
safety information about the use of the
battery pack.
To insert batteries into the racing wheel AA
battery pack:
1 Remove the battery cover from the base of
the racing wheel.
2 Press the tab on the top of the AA battery
pack and pull down to detach it from the
racing wheel.
3 Insert two new AA (LR6) batteries with
their positive (+) and negative (–) ends
positioned as shown on the underside of
the battery pack. For best performance,
AA rechargeable batteries are not
recommended.
4 Slide the AA battery pack back into place
on the controller and push in to lock.
5 Replace the battery cover.
NOTE
To avoid pinching your ngers when inserting,
push only on the at surface of the battery
pack.
NOTES
• If you use batteries instead of the power
supply, force feedback will not be active.
• If you’re using the Xbox 360 Rechargeable
Battery Pack, the racing wheel will charge
your battery pack whenever the battery
pack and the AC power supply are both
connected. Charging will not interfere with
force feedback.
Remove Batteries Aboard Aircraft
Before packing the racing wheel in
luggage that will be checked on an
aircraft, remove any batteries from the
racing wheel. The racing wheel can
transmit radio frequency (RF) energy,
much like a cellular telephone, whenever
batteries are installed.
Remove Batteries Aboard Aircraft
Before packing the racing wheel in
luggage that will be checked on an
aircraft, remove any batteries from the
racing wheel. The racing wheel can
transmit radio frequency (RF) energy,
much like a cellular telephone, whenever
batteries are installed.
Connect Your Racing Wheel
Up to four racing wheels can be actively
connected to a console at one time. Each
connected racing wheel gets a quadrant on
the Ring of Light. Before you can connect
a racing wheel, at least one quadrant must
be free (unlit). To disconnect a racing wheel,
press and hold the Xbox Guide button for
three seconds, and then turn it off.
To connect your racing wheel to your console:
1 Press and hold down the Xbox Guide
button or the Start button until the racing
wheel turns on.
2 If your console is not on, press the power
button to turn on the console.
3 Press and release the connect button on
the console.
4 Press and release the connect button on
the racing wheel.
5 After the Ring of Light (on the console and
on the racing wheel) spins and ashes
once, the racing wheel is connected. The
quadrant that remains lit indicates the
racing wheel’s position.
To Next Page
Loading...
Need help?
General
