MSB780(X) - User’s Guide
14.21 V 1.17
• Added specifiers QNH, QFE, HCP, P3H, A3H, TP1, TP2, TP3, DP12, DP13, DP23 for the
form command.
14.22 V 1.18
• Added SDI-12 commands for setting HQFE, HQNH, TQFE, HHCP, DPMAX, K1, Q1, K2,
Q2, K3, Q3 parameters.
• Added SDI-12 command aM1! to get measurement also with HQFE, HQNH parameters
• Added drawings.
The new features are implemented in firmware 046 and higher.
14.23 V 1.19
• Added transfer standard section
• Minor corrections
14.24 V 1.20
• Added Alarm subsection
• Added Analog output connection section
• Added Terminals of the TS
• Minor corrections in Interface menu subsection
14.25 V 1.21
• Added new screenshots
• Minor corrections
14.26 V 1.22
• Added new screenshots
• Added commands dt, setdt, dir e:, type <filename>
102
To Next Page
Loading...
