MSB780(X) - User’s Guide
6.8 “help” Display help
The help<cr> command displays list of available serial interface commands with a short de-
scription.
6.9 “boot” Restart device
This command can be used to restart the device.
Example:
boot<cr>
6.10 “seri” Set communication settings for user RS-232
Possible baud rates are the following: 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200, 230400.
This command can be used for change UART (RS-232) or RS-485 parameters.
The command affects settings on the port currently connected. If you issue the command via
RS-232, the settings will be used only for RS-232.
When connected via service port, the settings of RS-232 or RS-485 may be changed via prior
redirection to the respective port - see commands terminal rs232 or terminal rs485.
Example:
seri<cr>
SERI: [baud parity databits stopbits] “9600 n 8 1“<cr><lf>
New values: 19200 n 8 1<cr>
wait..OK<cr><lf>
6.11 “echo1” Enable echo
To enable echoing characters on the port currently connected, use this command.
Example:
echo1<cr>
Echo is ON<cr><lf>
38
To Next Page
Loading...