Microtest 6377 - Page 56

6–18
MEASUREMENT MODE
:MEAS:LEVel <real>
Set drive level for currently selected test.
Parameters:
The required level in Volt. The unit
suffix ‘V’ is optional.
Example: MEAS:LEV 1.2V
MEAS:LEV 200m
will select drive levels of 1.2V and
200mV respectively.
Response:
None.
:MEAS:LEVel?
Drive level query.
Parameters:
None.
Response:
Returns the current test level in
engineering format.
Example: +.20000000E-01
for a test level of 20mV.
:MEAS:SPEED <disc>
Select the required measurement speed.
Parameters:
MAX Maximum speed.
FAST Fast speed.
MED Medium speed.
SLOW Slow speed.
Example: :MEAS:SPEED SLOW
will select slow speed for
measurements.
Response:
None.
:MEAS:SPEED?
Returns the current test speed.
Parameters:
None.
Response:
Returns the test speed as an integer
according to the table:
0 Maximum
1 Fast
2 Medium
3 Slow
Example: 1
indicates that Fast measurements are
selected.