Micsig SATO1004 User Manual

Micsig SATO1004 Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Vertical Resolution	8 bits
Input Coupling	DC, AC, GND
Power Supply	100 - 240 VAC, 50/60 Hz
Input Impedance	1 MΩ ± 2%
Trigger Types	Edge, Pulse, Video, Slope
Interface	USB, LAN, HDMI

Summary

Chapter 1. Safety Precautions

1.1 Safety Precautions

General safety guidelines to prevent injury and damage.

1.2 Safety Terms and Symbols

Defines safety terms and symbols used in the manual and on the product.

Chapter 2. Quick Start Guide of Oscilloscope

2.1 Inspect Package Contents

2.7 Power on/off the Oscilloscope

Steps for powering the oscilloscope on and off.

2.11 Connect Probe to the Oscilloscope

Procedure for connecting oscilloscope probes.

2.12 Use Auto

2.15 Passive Probe Compensation

Chapter 3 Automotive Test

3.1 Charging/Start Circuit

Testing automotive charging and starting circuits.

3.2 Sensor Tests

Testing various automotive sensors.

3.3 Actuators

Testing automotive actuators.

3.4 Ignition Tests

Testing ignition systems.

3.5 Networks

Chapter 4 Operate the Oscilloscope with Buttons

4.1 Function Buttons

Chapter 5 Horizontal System

Chapter 6 Vertical System

Chapter 7 Trigger System

7.1 Trigger and Trigger Adjustment

7.2 Edge Trigger

7.10 Serial Bus Trigger and Decode

Chapter 8 Analysis System

8.1 Automatic Measurement

Chapter 12 Sampling System

12.3 Select Sampling Mode

12.4 Record Length and Sampling Rate

Chapter 13 Serial Bus Trigger and Decode

13.1 UART (RS232/RS422/RS485) Bus Trigger and Decode

UART trigger and decode.

13.3 CAN Bus Trigger and Decode

CAN bus trigger and decode.

13.5 I2C Bus Trigger and Decode

I2C bus trigger and decode.

Chapter 15 Remote Control

15.1 Host Computer

15.2 Mobile Remote Control

Chapter 18 Troubleshooting

1. If the oscilloscope does not start up at power on, please follow steps below

Power-on troubleshooting.

16. Function buttons are pressed without response