28 Chapter 3: Using The VeniceF With FireWire
VeniceF
Operator Manual
Troubleshooting FireWire
The following subsections may help you overcome any problems that may arise when
using FireWire.
Audio problems
If you encounter any problems with the audio, for example, when recording, try
changing the FireWire settings (see “Step C — Configuring the FireWire settings for the
VeniceF” on page 22).
No devices found
Important:
The VeniceF must be switched on before the FireWire cable is connected to it.
If you see a ‘no devices found’ message, it means that the PC cannot detect a FireWire
device. To clear the message, do one of the following:
• Connect the VeniceF to the PC.
•If the VeniceF is already connected to the PC, check that the connections are good.
Overcoming ground loop problems
See Appendix E "Best Grounding Practice" on page 101.
To Next Page
Loading...
Need help?
General
