NOTE
Please be sure to use the accessories provided by our company to install this electric
water heater. This electric water heater can not be hung on the support until it has been
confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from
the wall, resulting in damage of the heater, even serious accidents of injury. When
determining the locations of the bolt holes, it shall be ensured that there is a clearance
not less than 0.2m on the right side of the electric heater, to convenient the maintenance
of the heater, if necessary.
7
4. METHODS OF USING
NOTE
During normal operation, the inlet valve shall be always kept open.
First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet
valve. The water heater gets filled with water. When water flows out of the outlet pipe it implies
that the heater has been filled fully with water, and the outlet valve can be closed.
Insert the supply plug into the supply socket, the indicator will light up this time.
The thermostat will automatically control the temperature. When the water temperature inside
the heater has reached the set temperature, it will switch off automatically, when the water
temperature falls below the set point the heater will be turned on automatically to restore the
heating.
●
●
●
1
2
①
Temperature knob：
●Turn the knob to adjust the temperature. The temperature increases when turning right and
decreases when turning left
1
②
2
Heating indicator:
●When the product is heated, the lamp is on, and when the heating is completed, the lamp
is off
③
●When the knob indicates Eco, the product temperature is set to about 55 °
●When the knob is turned to the icon, the product is set to 80 °, and more hot water can
appear
④
To Next Page
Loading...
Need help?
General
