58
16.Wireless control connection
NOTE: Due to special situation may be occured, we explicitly claim below: Not all of the Andriod and IOS
systems are compatible with APP. We will not be responsible for any issues as a result of the incompatibility.
When the air conditioning unit is of, into the query function of temperature, press
“ ”or “ ”to select rEC. ON or OF will be displayed in the temperature area to
indicate whether it is valid or invalid.
When the selection is invalid, the wire controller does not process
any remote control signals.
Press “Confrm” into setting state, press“ ”or “ ”to select , then press “Confrm”
to complete it.
When the air conditioning unit is of, into the query function of temperature, press
“ ”or “ ”to select Adr, the temperature zone will display -- or A, B. Where --
refers to the code setting of the wirecontroller.
When the air conditioning unit is of, into the query function of temperature, press
“ ”or “ ”to select INIt, the temperature zone displayed --.
Press “Confrm” into setting state, press“ ”or “ ”to select to "ON" , then press
“Confrm” to complete it.
: Restore factory Settings .
Press “Confrm” into setting state, press“ ”or “ ”to select , then press “Confrm”
to complete it.
After the wire controller resumes the factory parameter setting, the rotating parameter setting is restored
to 10 hours (the highest and lowest temperature are not set); The compensation of body temperature
is uncompensated; COOL and HEAT/single COOL mode is restored to COOL and HEAT model;
Restore the temperature range to the factory setting.
Remote receiving function is restored to be efective;
The address of the two-control frst-line controller is restored to the code switch.
Smart kit only support WPA-PSK/WPA2-PSK encryption and none encryption . WPA-PSK/WPA2-PSK
encryption is recommended.
Read the safety precautions carefully before installing the unit.
-- : The code setting of the wire controller shall prevail.
Remote control function selection of wire controller
Two - line controller address selection
SAFETY PRECAUTION
SAFETY PRECAUTION
Restore factory Settings
: The wire controller address setting.
Stated below are important safety issues that must be obeyed.
Applicable system: IOS, Android. (Suggest:IOS 9 and above, Android 6.0 and above)
To Next Page
Loading...
