SAFETY PRECAUTION
* The drawing above is based on the actual washer.
2. INTRODUCTION OF PRODUCTS
2.1 Name of parts
Symptom
Possible reason
Solution
1. Unusual
sound when
washing or
wash weakly
(motor with
sound)
a. Laundry is much more than rated
washing capacity.
b. pulsator is tangled with clothes or
blocked by things like coins.
d. Pulley broken or pulley screw is
loose .
e. Capacitor failure.
c. V-belt loose, broken or fall from
the strap wheel.
a. Reduce the laundry till the
pulsator can rotate normally.
b. Take off plug, remove the
pulsator and take out the
tangled clothes or other things.
c. Replace v-belt or reload the
v-belt.
d. Replace the pulley or tight the
pulley locking screw.
e. Replace the capacitor.
a. Power supply is cut off or poor
contact of plug and socket.
b.
c. Wash timer is in poor contact or
faulted.
d.
e. Wash motor failure.
Voltage is too low.
Fuse is burned.
3. Electric
leakage
a. Conductive wire or alive parts in
the machine contacts with metal
cabinet.
b. Bad earth wire.
c. 2 power lines of the power supply.
d. Weak insulation strength of motor
e. Insulation layer of wire harness is
broken.
a. Check the power supply and
adjust the plug to insure good
contact.
b.
c. Check the wire harness or
replace the wash timer.
d.
e. Replace the wash motor.
Do not use the washing
machine until the voltage rise to
rated voltage.
Replace the fuse.
a. Check wire connecting in the
machine.
b. Check the earth wire.
c. Examine and replace the power
supply.
d. Replace the motor.
e. Examine the wire harness and
bind up the broken wire.
2. Can not wash
(motor does
not rotate)
3.TROUBLE SHOOTING
3.1 Malfuction and solution
-4--3-
Control panel
Wash cover
Pulsator
Base
Cabinet
Drain hose
Frame
(For lower drain only)
Drain hose
(For upper drain only)
Power plug
To Next Page
Loading...
Need help?
General