Symptom
Possible reason
Solution
3.TROUBLE SHOOTING
a. There is things like coins, buttons
under the pulsator.
b. The fixing screw become loose
and the pulsator vibrates.
c. Gear in the retarder is damaged.
d. Anti-loose nuts on the big pulley
become loose, so the wheel
jumps and make unusual noise.
e. The v-belt is not smooth and
makes noise when running on the
pulley.
f. The motor pulley and the big
pulley is not at a level.
g. Noise inside the wash motor.
a. Dismantle the pulsator and take
out the things.
b. Tighten the fixing screw.
c. Replace the retarder.
d. Screw tight the anti-loose nuts.
e. Replace the v-belt.
f . Adjust the motor pulley to make
it at the same level with the big
pulley.
g. Replace the wash motor.
4.Unusual
sound when
pulsator
rotates
-6--5-
a. Wash tub leaks.
b. Seal ring of the retarder leaks.
c. The overflow hose brakes and
water leaks from the broken place.
d. Drain valve core brakes and water
leaks from the valve cover.
e. Drain hose joint is badly bound
and water leaks from the joint
place.
a. Replace the wash tub.
b. Replace the seal ring of the
retarder.
c. Replace the overflow hose.
d. Replace the drain valve core.
e. Dismantle drain hose joint and
stick them again.
5. Water
leakage from
the side of
washing tub
a. When draining, the hose is not put
down and the water can not be
drained.(for lower drain function
only)
b. Wash -drain selection switch is
not in “drain”position.
e. Drain outlet is blocked at the side
of wash tub.
f. Drain falls from the switch.
g. Drain belt is loosened or broken.
c. Drain outlet is not laid properly.
(for upper drain function only)
d. Drain pump failure
( for upper drain function only).
belt
a. Put down the drain hose and
make the hose mouth to the
sewer.
c. The drain hose should be placed
86 cm-100cm from the bottom of
the ground.
e. Dismantle the pulsator and take
out the blocks at the drain outlet .
f. Connect the drain with the
switch.
g.Replace the drain belt.
b. Turn the switch to “drain” position
d. Replace the pump or open the
valve cover to clear up the pump.
belt
6. No drain or
unsmooth drain
Can not wash
Y
Y
N
N
N
Y
Y
Y
N
N
Whether the power
supply is well
Check the power supply
Whether the plug
is contact
Adjust the plug to insure
good contact
Whether the voltage
is correct
Wait the voltage to rise
to correct voltage
Whether the wash
timer is well
Y
N
Replace the wash timer
Whether the fuse
is well
Replace the fuse
Whether the capacitor
is well
Replace the capacitor
Y
N
Whether the wash
motor is well
Replace the wash motor
3.TROUBLE SHOOTING
1. Can not wash (motor does not rotate)
3.2 Fault tree
To Next Page
Loading...
Need help?
General