Midea FP-90LST060GMTL-N Service Manual

-8--7-
3. No drain or unsmooth drain
Can not drain
Y
Y
N
N
N
Y
Y
Y
N
N
Whether the drain
hose is put down
Put down the drain hose
Whether the wash-
drain selection switch is
not in “drain”position
Whether the drain
hose is laid properly
Whether the drain
pump is well
Y
N
Replace the drain pump
Whether the drain
hose at the side of
wash tub is blocked
Dismantle the pulsator
and take out the blocks
in the water drain hose
Whether the drain
belt is on the switch
Hang the drain
belt onto the switch
Y
N
Whether the drain
belt is well
Replace the drain belt
Turn the switch to “drain”
position
The drain hose should be
placed 86cm-100cm from
the bottom of the ground
for lower drain function only
for upper drain function only
for upper drain function only
3.TROUBLE SHOOTING 4.DISMANTLING WAYS OF MAIN PARTS
1. Remove the knobs
a.Take out the knobs directly
because knobs are inserted
into the control panel.
b. If it is difficult to take knobs out,
a straight screwdriver wrapped
with cloth can be used for help.
Operation step
Picture
a.
b.
2. Remove the control panel
a. Take down the back cover by
loosen-ing off the screws.
b. Take down the plastic bag by
cutting off the nylon clip. Take
down all wire nut with a plier
and make all wire clamps loose.
and then unfasten the drain belt
connector.
c. Screw off the screws on the
control panel.
d. The control panel can be lifted
and removed.
a. b.
c.
d.
a.
3. Remove the wash cover
a
draw out the wash cover with
the help of a screw-driver.
. Keep the wash cover open and

Midea FP-90LST060GMTL-N Specifications

General

Brand	Midea
Model	FP-90LST060GMTL-N
Category	Washer
Language	English