Midea G06

Error
Code
Unit
Action
Causes Explanation
E12
Overflowing.
Unit will close
valve and stop
with Error code
display
Restart
Some time just restart the unit can solve
the problem.
Water inlet valve
(The voltage on
the water inlet
valve is normal)
If the washer is overflowing, the water
inlet valve has failed. Replace it.
Water level sensor
or
control switch
(No voltage on the
water inlet valve)
A water lever control switch controls how
much water enters the washing machine
by PCB. If the water level control switch is
defective, or more commonly, if the small
air pipe attached to the air bell restricted,
The switch will not be able to close the
electrical contacts to the washer fill valve.
CHECK THE AIR PIPE
CHECK THE WATER LEVERL SENSOR
CHECK THE PCB and the inner wire
between PCB and the sensor
4. MALFUNCTION CODES AND EXPLANATIONS
19