Midea HS-338FWEN-W

24
9.3 Display screen
1 Super Freeze
2 Gear 1—— -24℃
3 Gear 2—— -22℃
4 Gear 3—— -20℃
5 Gear 4—— -18℃
6 Gear 5—— -16℃
9.4 Display
At the first time of power-on, the display screen (including button light) will be bright for 3
seconds and then press the middle gear to show operation
Normal operation display
When failure occurs, the corresponding LED light group will display fault code (circular
display);
If no failure occurs, the current operation gear will be displayed.9.5
Setting of the gear
9.6 Super Freeze
Enter: Cyclic Modulation Quick freezer mode
Operation: The “super” indicator light is on and the refrigerator is running at super freezer
mode
Exit:
1.Ssuper freezer mode running 24hour
2.Super freezer mode, the temperature can be cooled out of the cold
9.7 Fault code and solutions
Fault
code
Fault
content
Code
visible
Display Steps for maintenance methods
E1
Temperatur
e sensor
fault in
refrigerating
chamber
Yes
“On”
of
Super and -24
simultaneousl
y
Step 1: Check whether the terminal CN4 is well stuck,
pull out the terminal and re-stick it in place
Step 2: Check to see if there’re foreign matters
on the
terminal.
Step 3: inspect the refrigerating sensor whether contact
is bad, and resend contact the fast connector
Step 4: Replace main control board