Remote Control
Instructions
26
This feature can be activated from the remote control
ONLY. To activate SLEEP feature, the set temperature
will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then
increase(cooling) or decrease(heating) by another 1°C
/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
thermostat allowing for the precise temperature
control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the
unit and press the Follow Me/Temp Sensing button.
The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing
button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval,
the unit will exit the Follow Me/Temp Sensing mode.
UNSURE ABOUT A FUNCTION
Refer to the "How to Use Basic Functions" and "How to
Use Advanced Functions" sections of this manual for a
detailed description of how to use your air conditioner.
Handling the Remote Controller
Your air conditioning unit comes with two AAA batteries.
Put the batteries in the remote controller before use.
For optimum product performance:
Inserting and Replacing Batteries
Do not dispose of batteries as unsorted municipal waste.
Refer to local laws for proper disposal of batteries.
BATTERY DISPOSAL
SPECIAL NOTE
•
•
•
Button designs on your unit may differ slightly
from the example shown.
If the unit does not have a particular function,
pressing that function button on the remote
controller will have no effect.
If the function description in the OPERATOR'S
MANUAL and "Remote Controller Illustration" is
significantly different, the description in the
OPERATOR'S MANUAL shall prevail.
TIPS FOR USING THE REMOTE CONTROLLER
•
•
•
The remote controller must be used within 8
meters of the unit.
The unit will beep when the remote signal is
received.
Curtains, other materials, and direct sunlight can
interfere with the infrared signal receiver.
• Remove batteries if the remote will not be used
for more than 2 months.
BATTERY NOTES
•
•
Do not mix old and new batteries. Do not mix
alkaline, standard(carbon-zinc),or recharge-
able(ni-cad,-ni-mh,etc) batteries.
Do not leave controller if not batteries planning in
to the use remote device for more than 2 months.
1.
2.
3.
Slide the back cover from the remote controller
downward, to expose the battery compartment.
Insert the batteries, making sure to match up the
(+) and (-) ends of the batteries with the symbols
inside the battery compartment.
Slide the battery cover back into place.
To Next Page
Loading...
