Midea MAP06R1BWT - Page 28

Remote Control
Instructions
In Auto mode, the unit will automatically select the
COOL, FAN, HEAT(on some models), or DRY mode
based on the set temperature.
1.
2.
3.
Press the MODE button to select Auto THE mode.
Set your desired temperature using the Temp
or Temp button.
Press the ON/OFF button to start the unit.
Press the MODE button to select the COOL mode.
Set your desired temperature usingthe Temp
or Temp button.
Press the FAN button to select the fan speed:
AUTO, LOW, MED(on some models),or HIGH.
Press the ON/OFF button to start the unit.
28
This feature can be activated from the remote control
ONLY. To activate SLEEP feature, the set temperature
will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then
increase(cooling) or decrease(heating) by another 1°C
NOTE: FAN SPEED cannot be set in Auto mode.
/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
thermostat allowing for the precise temperature
control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the
unit and press the Follow Me/Temp Sensing button.
The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing
button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval,
the unit will exit the Follow Me/Temp Sensing mode.
UNSURE ABOUT A FUNCTION
Refer to the "How to Use Basic Functions" and "How to
Use Advanced Functions" sections of this manual for a
detailed description of how to use your air conditioner.
How to Use the Basic Functions
The operating temperature range for units is 17-30
O
C
(62
O
F-86
O
F). You can increase or decrease the set
temperature in 1
O
C (1
O
F) increments.
SETTING THE TEMPERATURE
AUTO Operation
COOL Operation
1.
2.
3.
4.
1
3
2
1
3
2
4