Aqua Tempo Super II
32 201709
Midea Aqua Tempo Super II
Service Manual
Total water outlet temperature sensor
Compressor output control
3
Electric auxiliary heater control
Compressor output control
3
Water side heat exchanger anti-freeze
protection control
8
Inverter module temperature sensor 1/ Inverter module
temperature sensor 2
Compressor output control
3
Inverter module temperature
protection
11
Compressor output control
3
Outdoor fan control
5
Inverter module temperature
protection
11
Notes:
1. Refer to part 3, 3.1 “Crankcase Heater Control".
2. Refer to part 3, 5.6 “Electronic Expansion Valve Control".
3. Refer to part 3, 5.2 “Compressor Output Control".
4. Refer to part 3, 6.3 “Discharge Temperature Protection Control".
5. Refer to part 3, 5.7 “Outdoor Fan Control".
6. Refer to part 3, 7.2 “Defrosting Operation".
7. Refer to part 3, 6.8 “Air Side Heat Exchanger High Temperature Protection Control".
8. Refer to part 3, 6.7 “Water Side Heat Exchanger Anti-freeze Protection Control ".
9. Refer to part 3, 6.10 “Water Side Heat Exchanger Low Temperature Protection Control ".
10. Refer to part 3, 6.9 “Water Side Heat Exchanger Temperature Difference Protection Control ".
11. Refer to part 3, 6.4 “Compressor and Inverter Module Protection Control "
12. All sensor names in his service manual referring to refrigerant flow is named according refrigerant flow during cooling operation refer to
part2,3 ”Refrigerant Flow Diagram ”.