Midea MCD1-24HRFNX - Page 37

Step 2: Remove the installation covers at
the four corners by sliding them outwards.
Step 3: Install the panel
Align the front panel to the main body, taking
into account the position of the piping and
drain sides. Hang the four latches of the
decorative panel to the hooks of the indoor
unit. Tighten the panel hook screws evenly at
the four corners.
NOTE: Tighten the screws until the thickness
of the sponge between the main body and
the panel reduces to 4-6mm (0.2-0.3”). The
edge of the panel should be in contact with
the ceiling well.
Adjust the panel by turning it to the arrowed
direction so that the ceiling opening is
completely covered.
(B)
Remove the grid screws
Grille switch
Step 5: Fasten the control box lid with 2
screws .
Step 6: Close the intake grille, and close
the 2 grille hooks.
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the
grille.
2. Hold the grille at a 45° angle, lift it up
slightly and detach it from the main body.
45°
Grille screw cover
4-6mm
Piping interface
Drainage interface
louver motor
Ceiling
Main body
Into the wind
Out of the wind
Panel foam 1
Panel foam 2
Outlet foam
Panel
Panel side
sponge
Bae
35