CAUTION
Hang the intake grille on the panel, and then
connect the lead connectors of the louver motor
and the control box on the panel to the
corresponding connectors of the main body.
Re-installed into the style grid.
Reinstall the installation cover.
Fix the installation cover plate rope to the pillar of
the installation cover plate, and gently press the
installation cover plate into the panel.
Water condensation
NOTE: If the height of the indoor unit needs
to be adjusted, you can do so through the
openings at the panel’s four corners. Make
sure that the internal wiring and drainpipe
are not aected by this adjustment.
NOTE: After installation, the butt plugs
of display, swing, water pump and other
wire bodies must be placed in the
electric control box.
Failure to tighten screws can cause water
leakage.
CAUTION
If the unit is not hung correctly and a gap
exists, the unit’s height must be adjusted
to ensure proper function. The unit’s height
can be adjusted by loosening the upper nut,
and adjusting the lower nut.
Loosen upper nut
1
2
Adjust lower nut
Gap not allowed
Bolt
Install cover rope
Panel hook
When installing the
cover, slide the four
slide fasteners into
the corresponding
slots on the panel.
36
To Next Page
Loading...
