Preparation for Use
Installation and removal of the handle
To install:
Insert the end of the handle into the port of the
main unit in the vertical direction until there is
a click sound, which indicates that the
installation is successful.
Charging the machine
Note: Charge the product before first use.
1. Place the machine on the base.
2. Insert the charging end of the adapter into the charging port (as shown in the figure), and connect to
the power supply. The ON/OFF key indicator is always ON and stays blue during charging.
3. It takes approximately 5 hours to fully charge the unit. When the battery is fully charged, the ON/OFF
key indicator goes out.
4. When charging, keep it close to the corner of the wall to avoid tripping and other injuries.
To remove:
To remove and store, find the round hole on the
back of the unit, insert a screwdriver or other tool
into the round hole to the bottom, and pull out the
handle in the vertical direction at the same time.
Insert
Pull out
Handle removal hole
Charging port
Wall
To Next Page
Loading...
