5
Specifications subject to change without notice.
REMOTE CONTROLLER FUNCTIONS
NOTE: The indoor unit beeps for 2 seconds indicating the function
has been successfully set.
Auto−Start Function (F1)
In the event of a sudden power failure, the module memorizes the
setting conditions before the power failure. The unit resumes the
previous operation setting automatically after 3 minutes when the
power returns. To enable/disable this function:
1. Press
and to select “F1”.
Fig. 11 - Select F1
2. Press MODIFY. Next, press and to choose ON or OFF.
Fig. 12 - Select On or Off
3. Press CONFIRM to complete the Auto−start function.
Fig. 13 - Fan
Heating Temperature Compensation (F2)
Defines the adjustment for the thermal stratification in the room and
how the indoor unit is sensing the space. To adjust the temperature
compensation, in Celsius only.
NOTE: The temperature compensation in Celsius regardless of the
units used.
1. Press
and to select “F2”.
Fig. 14 - Select F2
2. Press MODIFY. Next, press
and to select the parameter.
The parameters can be adjusted within a range of 21.2_F~
42.8
_F (−6_C ~ 6_C).
Fig. 15 - Select the parameter
3. Press FAN+ to CONFIRM.
Fig. 16 - Confirm
Anti−Cold Air Function (F3)
A) Intelligent Anti−Cold Air Function
NOTE: The intelligent anti−cold air parameter changes with the room
temperature. Once the room temperature rises, the anti−cold air
temperature rises as well, which is designed to provide the user with
increased comfort. After the room temperature decreases, the anti−cold
temperature decreases as well, which is designed to improve fan speed
and result in a faster heating operation.
NOTE: No setting adjustment recommended.
1. Press
and to select “F3”.
Fig. 17 - Select F3
2. Press MODIFY. Next, press
and to select “1”.
Fig. 18 - Select 1
3. Press MODIFY to adjust the parameter. The parameter
continues to flash. The parameter can be adjusted in the range
of 63
_F (17_C) ~ 70_F(21_C).
Fig. 19 - MODIFY
4. Press FAN to confirm.
Fig. 20 - Confirm
To Next Page
Loading...
Need help?
General
