6
Specifications subject to change without notice.
B) General Anti−Cold Air Function Setting (Cold Blow Prevention
Function)
The general anti−cold air parameter is set regardless of the room
temperature.
NOTE: No setting adjustment recommended.
1. Press
and to select “F3”.
Fig. 21 - Select F3
2. Press MODIFY. Next, press
and to select “2”.
Fig. 22 - Select 2
3. Press MODIFY to adjust the parameter in the range of
46
_F(8_C) ~ 82_F(28_C)).
Fig. 23 - Adjust the parameter
4. Press FAN+ to CONFIRM.
Fig. 24 - FAN
Indoor Fan Motor Speed Control after Set
Temperature is Reached (F4)
1. Press and to select “F4”.
Fig. 25 - Select F4
2. Press MODIFY. Next, press and to select
“1”,“2”,“3”,“4”.
Fig. 26 - Select a number
3. Press FAN+ to CONFIRM.
Fig. 27 - FAN
Louver Angle Memory Function (F5)
1. Press and to select “F5”.
Fig. 28 - Select F5
2. Press MODIFY. Next, press
+ and - to select “1”, “2”, or “3”.
Fig. 29 - Select a number
3. Press FAN+ to CONFIRM.
Fig. 30 - FAN
To Next Page
Loading...
Need help?
General
