Midland CT990 instruction guide | 13
VOX Delay - Menu Utilities 15
There’s a brief delay between when you finish talking and the radio returns to tx
mode; this delay can be adjusted.
In standby mode press Menu Utilities + 15; “VOX DELAY” will appear on the
display.
Press Menu to enter the function. The display will show dierent options: se-
lect the desired delay time with the ▼/▲ buttons or rotate the encoder.
Push Menu for confirmation and return to standby mode by pushing Back.
TOT function (Time Out Timer) - Menu Utilities 16
The TOT function is used to prevent a too long transmission. This function
temporarily blocks transmissions if the radio has been used beyond the maxi-
mum time permitted. Once reached the preset timer, the radio will be forced
in reception mode. When a transmission exceeds the pre-set time, you will
hear a warning sound to remind you that the transmission time is almost fi-
nished.
The transmission time can be set in 60 levels with 15 seconds each (between
15 and 600 seconds).
In standby mode, press Menu Utilities + 16; the screen will display “TOT”.
Push Menu to enter the function. Press the ▲/▼ buttons or rotate the enco-
der to select the desired TOT level, then press Menu to confirm.
To return to the standby mode press Back.
Roger Beep, end transmission tone (ROGER BEEP) - Menu
Utilities 17
Roger Beep can be enabled/disabled:
OFF: Roger Beep disabled
ON: Roger Beep tone at the end of transmission
In Standby mode press Menu Utilities + 17; the display will show “ROGER
BEEP”.
Press Menu to enter the function.
Select ON/OFF with the ▼/▲ controls or rotate the encoder. Push Menu to
confirm your selection and then Back to return in standby condition.
To Next Page
Loading...
