20 | Midland CT990 instruction guide
Functions enabled in channel mode only
Adding a channel to scan (SCAN LIST) - Menu Utilities18
It it possible to add a channel to the scan channel list. To enable it, you must
first set the radio to CH mode.
In Standby mode press Menu Utilities + 18; the display will show “SCAN-LIST”.
Push Menu to enter the function. Press ▼/▲ or turn the encoder to activate
and confirm by pushing Menu.
To return in standby condition, press Back.
Setting the priority channel (SCAN PRIORITY) - Menu
Utilities 19
The priority channel can be set with the optional programming software.
The SCAN PRIORITY feature is related to the scan function; the options
available are two: OFF/ON.
In Standby mode press Menu Utilities + 19; “SCAN PRIORITY” will be di-
splayed.
Press Menu to enter the function. With the ▼/▲ keys or by turning the enco-
der you can select the channel; then confirm with Menu. Push Back to return
in standby condition.
The radio will alternately scan the channels and the priority channel.
Working modes (CH-Freq + CH-Display) - Menu Utilities 34
CT990 has 4 working modes available:
• Frequency mode (FREQ)
In channel mode the following modes can be set:
• Channel mode (CH).
• Frequency + channel number (CH FREQ)
• Channel name (NAME)
• In Standby condition press # to select the desired working mode.
To Next Page
Loading...
