for 5 seconds approx.
MON (Monitor) function / Squelch
The Monitor button is for temporarily excluding (opening) the squelch,
in order to listen to signals that are too weak to keep the squelch perma-
nently opened.
To activate the monitor function, keep pressed for about 2 seconds both
▲▼ at the same time. Follow the same procedure to deactivate the fun-
ction, or switch off and on the radio.
When MON is active, you will probably hear a constant background noise.
You can activate the Monitor feature only if the “Emergency” function is
disabled.
Scanning all the channels
Midland G9 Plus can automatically search for signals throughout the
bands by scanning the channels in rapid sequence. This function is useful
to find out any active channel.
When a signal is detected, the scanning pauses on that channel for 5 se-
conds.
Press ▲ for 2 seconds: the scanning will start.
To stop it, push PTT: the Midland G9 Plus will go back to the channel
from which the scanning originally started.
You can activate the scanning feature only if the “Emergency” function
is disabled.
“MENU” key
The following features can be selected by using the “MENU” button:
› Channel selection
› CTCSS tone setting
› DCS tone setting
› High/low power selection (only in the PMR446 band)
› VOX
› VibraCALL function