Midland G9 User Manual

16 | Midland G9/G9E Plus instruction guide
tone blinks on the right (“of”= no code – default condition).
4. Select the desired CTCSS tone by pushing ▲▼.
5. To confirm the setting, push PTT or wait for 5 seconds.
Deactivating the CTCSS tones:
If you don’t want to use the CTCSS tones, follow these steps:
1. Select the desired channel
2. Press the MENU key till the display shows the CTCSS tone blinking
on the left;
3. Select “of” by means of ▲▼.
Activating the DCS codes:
1. Turn on the unit.
2. Select the desired channel by pressing MENU and ▲▼ keys.
3. Push the MENU button again till the display shows DCS and the tone
code blinks on the right (“of”=no code – default condition).
4. Select the desired DCS code by pushing ▲▼.
5. To confirm the setting, press the PTT or wait for 5 seconds.
Channel P8 with DCS tone 50 (P850) has been set at factory for the “Emer-
gency” function; do not use it for general communications!!
Deactivating the DCS codes:
1. Select the desired channel.
2. Press the MENU key till the display shows the channel in use and the
DCS code blinks on the right.
3. Select “of” by pushing ▲▼.
Hi/low power selection (only in PMR446 band)
1. To select the power level, press the MENU button till the display
shows Pr.
2. Use ▲▼ to select L (low power) or H (high power).
3. To confirm your selection, push PTT or wait for 5 seconds.
When the batteries are fully charged, the high power is 500 mW (ERP),
while the low is 10mW (ERP).
If your radio has to operate within a short range, you can select the low
power and therefore extend the battery life.
On LPD channels (only for G9 Plus Dual band version) the output power

Midland G9 Specifications

General

VOX	Yes
Water Resistance	IPX4
Display	LCD
Frequency Range	446.00625 - 446.09375 MHz
Channels	8
Output Power	500 mW ERP (PMR446); 10 mW (LPD433)
Weight	120 g (without batteries)